It is currently Thu Mar 28, 2024 4:32 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 77 posts ]  Go to page Previous  1, 2, 3, 4, 5, 6  Next
Author Message
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jun 10, 2018 7:08 pm 

Joined: Sat Oct 17, 2015 5:55 pm
Posts: 2279
Have any roofing tar that comes in a gallon paint can? I think it might contain fiberglass, too. That would work until you can do a proper repair.


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jun 10, 2018 10:09 pm 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
PMC -

Will pass that idea along. Thanks.


Les


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jun 10, 2018 10:40 pm 

Joined: Sun Aug 22, 2004 7:19 am
Posts: 6399
Location: southeastern USA
There's a type of Bondo that has fibres intermixed in the epoxy which do wonders on less wide holes. Cat Hair is the unofficial name.... for the larger holes Great Stuff can fill the holes leaving a surface that can be sanded to just below the level of the steel, and then covered with Bondo. Neither will last for decades especially in service, but will buy you years in static display. Another possibility is a type of elastomeric roof coating that is used with a strip of fiber tape which is bedded in it, than covered with paintable elastomer. Leaving the holes open for water infiltration is a higher priority than a paint job for long term preservation - try some of these and see what works for you.

_________________
“God, the beautiful racket of it all: the sighing and hissing, the rattle and clack of the cars over the rails. These were the sounds that made America the greatest country on earth." Jonathan Evison


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jun 10, 2018 10:59 pm 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
Thanks Dave. Will also pass your comments along.

Les


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 11, 2018 1:51 am 

Joined: Sat Oct 17, 2015 5:55 pm
Posts: 2279
That's a good idea about the Great Stuff Dave. For those who haven't seen it it comes in a can like whipped cream topping does, it actually has the same consistency as whipped cream when wet but dries in a few minutes into something like a tough Styrofoam. If you could reach the bottom of the holes you could spray about a fist sized bunch of that stuff up there so that it plugs the hole from below, and then paint over the top of it.


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 11, 2018 11:13 am 

Joined: Thu Aug 26, 2004 2:50 pm
Posts: 2815
Location: Northern Illinois
PMC wrote:
That's a good idea about the Great Stuff Dave. For those who haven't seen it it comes in a can like whipped cream topping does, it actually has the same consistency as whipped cream when wet but dries in a few minutes...


More than a couple minutes. Great Stuff is a polyurethane foam that uses water vapor in the environment as the catalyst. After you fill the void with the foam as it comes out of the can, it will swell as it sets up... and continue to swell for the next day or so until it is completely cured. I used this years ago to fill the holes where knots had fallen out of the "rustic" siding on a house I bought. The missing knots exposed the black Celotex sheathing board behind, and all those black circles were irresistible to house sparrows and several other species of birds, who would start pecking at the Cellotex to enlarge the hole and provide nest site.

I filled the holes with Great Stuff and tooled it off as best I could as it set. The next day the house looked like it had warts, as the foam had continued to swell 2 to 3 times in volume. After it stopped swelling it was easy enough to rasp it flush with a Stanley "Sure Form" tool, but if it hadn't fully cured, it would swell out again. Once it stopped swelling and was smoothed off, it took solid color oil stain well enough. It's soft enough that the birds could easily peck it out; the secret is they don't see the resulting surface as a hole, so don't try.

I've also used it for lightweight scenery on a portable model railroad, using it to fill the gaps between pink foamboard. If it gets trapped, the resulting pressure is enough to bend 1" rigid foam, or blow the joints apart. But once cured it's stable and doesn't shrink. It would indeed be excellent for providing a backer than can be cut back to provide a recess for one of the polyester auto body fillers, but definitely leave it sit and cure several days before covering it.

_________________
Dennis Storzek


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 11, 2018 6:03 pm 

Joined: Sun Nov 25, 2012 7:22 pm
Posts: 65
Location: Northwest Indiana
Ya gotta be careful as some of those expanding foam products
will hold moisture.



Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 11, 2018 6:42 pm 

Joined: Sun Aug 22, 2004 7:19 am
Posts: 6399
Location: southeastern USA
Can't hold moisture that can't get in once the holes are filled and sealed.

_________________
“God, the beautiful racket of it all: the sighing and hissing, the rattle and clack of the cars over the rails. These were the sounds that made America the greatest country on earth." Jonathan Evison


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jun 17, 2018 9:15 pm 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
Mark continues to make progress on NKP 344. He opened the automobile doors on the one end of the car, as can be seen in the first two photos he took on 6/16. He also managed to clean and then paint the two trucks on one side of the car and the results on one of those trucks is shown in the third shot which I took earlier today (6/17). The green highlights are a reflection of the jade green paint from Penn Central box car #153177.

Les


Attachments:
Automobile doors NKP 344 on June 16, 2018.JPG
Automobile doors NKP 344 on June 16, 2018.JPG [ 343.01 KiB | Viewed 7003 times ]
Automobile doors NKP 344 June 16, 2018.JPG
Automobile doors NKP 344 June 16, 2018.JPG [ 214.51 KiB | Viewed 7003 times ]
Ninety five degree day at HVRM 6-17-18 007.JPG
Ninety five degree day at HVRM 6-17-18 007.JPG [ 336.13 KiB | Viewed 7003 times ]
Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 25, 2018 12:35 am 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
Mark cleaned off the vestibule door hardware as shown in his attached photo and believes it is brass.


Attachments:
June 24 2018 pix 2 NKP 344.JPG
June 24 2018 pix 2 NKP 344.JPG [ 252.82 KiB | Viewed 6708 times ]
Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jun 25, 2018 10:56 am 

Joined: Thu Aug 26, 2004 2:50 pm
Posts: 2815
Location: Northern Illinois
Locks and door hardware were traditionally brass; no reason to suspect it isn't.

_________________
Dennis Storzek


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Tue Jun 26, 2018 9:31 pm 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
Mark has furnished these two photos as he starts on NKP 344's roof.


Les


Attachments:
June 26 2018 NKP 344 roof pix 1.JPG
June 26 2018 NKP 344 roof pix 1.JPG [ 249.92 KiB | Viewed 6481 times ]
June 26 2018 NKP 344 roof pix 2.JPG
June 26 2018 NKP 344 roof pix 2.JPG [ 340.66 KiB | Viewed 6481 times ]
Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Wed Jun 27, 2018 12:25 am 

Joined: Tue Jul 06, 2010 1:57 am
Posts: 210
Man, it looks like y'all are doing a hell of a good job. Can't wait to see the finished product!


Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Sun Jul 01, 2018 9:06 pm 

Joined: Tue Aug 02, 2005 1:25 pm
Posts: 6400
Mark spent about 4-1/2 hours of this first day of July working on number 344 in the 90 degree heat and humidity. He reported that the rivet belt around the car and the windows in each of the 4 baggage car doors received 5 and a half tubes of calk. There was a 1/4" gap on these door windows allowing water to drip in rusting out the door faces. Two of the doors have Plexiglass windows while the other two have wood replacements for the original glass. Mark primed and then painted the two wood windows. The photos below show the results of his work.

Mark also painted the one side of the car using 2.2 gallons of Sherwin-Williams Pullman Green paint. He reported that the top of the roof and sides below the celestory strip took 3 gallons of gloss black and he used 1/3 of a gallon of MAB Pullman Green paint on the celestory strip itself.

Les


Attachments:
July 1 2018 NKP 344 baggage car door.JPG
July 1 2018 NKP 344 baggage car door.JPG [ 346.39 KiB | Viewed 6281 times ]
July 1 2018 NKP 344 baggage car door pix 2.JPG
July 1 2018 NKP 344 baggage car door pix 2.JPG [ 349.84 KiB | Viewed 6281 times ]
Offline
 Profile  
 
 Post subject: Re: Nickel Plate baggage car #344 restoration starts at HVRM
PostPosted: Mon Jul 02, 2018 9:28 am 

Joined: Sun Aug 22, 2004 11:26 am
Posts: 4642
Location: Maine
This is an amazing show of what a group of dedicated people can do with facilities and individuals who a) know what they are doing, and b) show up for work.

That roof is tremendous.

_________________
"It's only impossible until it's done." -Nelson Mandela


Offline
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 77 posts ]  Go to page Previous  1, 2, 3, 4, 5, 6  Next

All times are UTC - 5 hours [ DST ]


 Who is online

Users browsing this forum: Google [Bot], Great Western, Majestic-12 [Bot], wesp and 123 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
 
cron