Railway Preservation News http://www.rypn.org/forums/ |
|
EMD Model 40 (dimensions needed) http://www.rypn.org/forums/viewtopic.php?f=2&t=22149 |
Page 1 of 1 |
Author: | Mr.Pullman [ Fri Sep 29, 2006 4:05 pm ] |
Post subject: | EMD Model 40 (dimensions needed) |
Hello Folks I need your help. I need very specific measurements for the EMD/EMC model 40. Below is what I need: EMC/EMD Model 40 dimensions Length & Width: Feet & Inches (need this to the nearest half inch) -Coupler face to coupler face -Frame end to end -Side to side (extreme out side to other extreme out side, hand rail body which ever is furthest out most) Height: Feet & Inches (need this to the nearest half inch) -Need this from wheel flange to extreme top of cab Weight: Need total weight of locomotive, with fuel and sand and with out. I thank you ahead of time for your help and guidance. Aside any guidance to a group listed below that owns one of these units that would be willing to assit would be welcome as well: a) Museum of Industry, Stellarton, Nova Scotia (Canada) b) Industrial Museum of York County (Pennsylvania) c) Hoosier Valley RR Museum, North Judson, IN d) Traveltown Museum, Los Angeles e) Walkerville Southern |
Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |