Railway Preservation News

EMD Model 40 (dimensions needed)
Page 1 of 1

Author:  Mr.Pullman [ Fri Sep 29, 2006 4:05 pm ]
Post subject:  EMD Model 40 (dimensions needed)

Hello Folks

I need your help. I need very specific measurements for the EMD/EMC model 40. Below is what I need:

EMC/EMD Model 40 dimensions

Length & Width: Feet & Inches (need this to the nearest half inch)
-Coupler face to coupler face
-Frame end to end
-Side to side (extreme out side to other extreme out side, hand rail body which ever is furthest out most)

Height: Feet & Inches (need this to the nearest half inch)
-Need this from wheel flange to extreme top of cab

Weight: Need total weight of locomotive, with fuel and sand and with out.

I thank you ahead of time for your help and guidance.

Aside any guidance to a group listed below that owns one of these units that would be willing to assit would be welcome as well:

a) Museum of Industry, Stellarton, Nova Scotia (Canada)
b) Industrial Museum of York County (Pennsylvania)
c) Hoosier Valley RR Museum, North Judson, IN
d) Traveltown Museum, Los Angeles
e) Walkerville Southern

Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group