It is currently Thu Mar 28, 2024 6:09 am

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Cane seat trim piece
PostPosted: Fri May 09, 2008 10:48 pm 

Joined: Mon Aug 23, 2004 12:29 pm
Posts: 88
Location: San Francisco, CA.
Greetings:

I am looking for 160 feet of copper strip (I believe it's plated with Nickel) with the roll in it at each side for the top cap strip for cane seats. The cross section is approx. 3/4". Does any one know where this can be purchased, or is any one else interested if I have some made ?

I have pictures of the item, I could not figure out how to insert these. Please contact me if you either know of a source, or are interested in having some produced.

Thank you

Karl Johnson
[/img]


Offline
 Profile  
 
 Post subject: Re: Cane seat trim piece
PostPosted: Sat May 10, 2008 7:06 am 

Joined: Sun Aug 22, 2004 7:19 am
Posts: 6399
Location: southeastern USA
Last time I needed this stuff I had to make do with a gold anodized aluminum strip gotten from an architectural metal supplier. It worked pretty well, but wasn't truly authentic.

dave

_________________
“God, the beautiful racket of it all: the sighing and hissing, the rattle and clack of the cars over the rails. These were the sounds that made America the greatest country on earth." Jonathan Evison


Offline
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


 Who is online

Users browsing this forum: No registered users and 22 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: