Railway Preservation News

Cane seat trim piece
Page 1 of 1

Author:  kjohnson [ Fri May 09, 2008 10:48 pm ]
Post subject:  Cane seat trim piece


I am looking for 160 feet of copper strip (I believe it's plated with Nickel) with the roll in it at each side for the top cap strip for cane seats. The cross section is approx. 3/4". Does any one know where this can be purchased, or is any one else interested if I have some made ?

I have pictures of the item, I could not figure out how to insert these. Please contact me if you either know of a source, or are interested in having some produced.

Thank you

Karl Johnson

Author:  Dave [ Sat May 10, 2008 7:06 am ]
Post subject:  Re: Cane seat trim piece

Last time I needed this stuff I had to make do with a gold anodized aluminum strip gotten from an architectural metal supplier. It worked pretty well, but wasn't truly authentic.


Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group