It is currently Thu Aug 27, 2026 6:20 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: "Rogers" Ballast Cars
PostPosted: Sat Oct 22, 2005 11:10 pm 

Joined: Sat Oct 22, 2005 10:51 pm
Posts: 9
I am looking for any information on "Rogers" ballast cars sold to the Patterson & Western RR in either very late 1915 or early 1916. There is some evidence they may have been built by Kilbourn & Jacobs (under license to Rogers?)These cars were numbered 40 to 49 on the P&W. all but #41 & 42 were sold by the United Commercial Co. (scrapper of P&W) in early 1921 to Eureka-Nevada ng (3'). Most of these cars were convered to flat cars with low side boards. I have only two, very poor, photos of these. Thanks, Dan


Offline
 Profile  
 
 Post subject: Re: "Rogers" Ballast Cars
PostPosted: Sun Oct 23, 2005 2:18 am 

Joined: Sun Aug 22, 2004 8:51 pm
Posts: 2055
Location: Southern California
For the E-N end, the best possible source that I can think of is Greg Maxwell of the Portland, Oregon, area. I have traveled E&P/E-N country with him. Greg set up the Nevada narrow gauge email group at Yahoo groups. Occasionally I've seen him post on the Narrow Gauge Discussion board.

_________________
Brian Norden


Offline
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: