| Railway Preservation News https://www.rypn.org/forums/ |
|
| Source for angle and globe valves? https://www.rypn.org/forums/viewtopic.php?f=1&t=2118 |
Page 1 of 1 |
| Author: | Dick Wilkes [ Wed Sep 19, 2001 10:21 am ] |
| Post subject: | Source for angle and globe valves? |
Does anyone have a source for 3/4 inch, 300 or 400 psi steam, locomotive service, angle and globe valves? The group I'm working with needs a couple of each, and their past supplier says they aren't available anymore. Thanks in advance. rwilkes99@yahoo.com |
|
| Author: | Ray Dewley [ Wed Sep 19, 2001 12:36 pm ] |
| Post subject: | Re: Source for angle and globe valves? |
Try Collins Pipe at 806-292-5341. They are a large plumbing supply house in East Windsor, CT. Collins Pipe |
|
| Author: | Edward Burger [ Wed Sep 19, 2001 11:20 pm ] |
| Post subject: | Re: Source for angle and globe valves? |
> Does anyone have a source for 3/4 inch, 300 > or 400 psi steam, locomotive service, angle > and globe valves? The group I'm working with > needs a couple of each, and their past > supplier says they aren't available anymore. > Thanks in advance. Check out the powellvalves.com website. eburger1@san.rr.com |
|
| Author: | HKA [ Thu Sep 20, 2001 8:20 pm ] |
| Post subject: | Re: Source for angle and globe valves? |
Nibco makes 300 PSI Teflon seat globe (figure T-375-Y), and angle (figure T-275-Y) valves that I have generally had good luck with. Nibco is a pretty big name in valves these days, and I would think that most any plumbing supply house could order them for you. Their funny looking handles take some getting used to, though. |
|
| Author: | HKA [ Thu Sep 20, 2001 8:27 pm ] |
| Post subject: | Also try McMaster-Carr at http://www.mcmaster.com/ *NM* |
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|