Need the know the follow:
Cab--- take loose a Pin to hold the body that Trucks. ____________
Truck--- __________

We got the rest.
We problem the is 25 Ton Granty Crane or 4- 100 Ton Jack.

The problem is cause the bad traction on one.


Stan

What exactly are you asking about? How to pull the truck center pin? The total wieght of the locomotive?

Owen's mother tongue is not English (correct me if I'm wrong). It would seem that he is trying to figure out the component weight of a GE 45 tonner that has a bad traction motor so he can gauge the proper crane capacity to lift the engine off that truck (lifting on only one end of the locomotive frame. He might also be looking for how to pull the locking pin for the truck to allow removal.

Least, that's how I read it.

Michael Seitz
Missoula MT

http://www.sdrm.org/gallery/campo/bridge-crane-4.jpghttp://www.sdrm.org/roster/diesel/d-7485/d-7485-1.jpg The Weight of the cab is on the Loco in-Tons________
The Weight of each Truck in per unit-Tons ________

Thank you

Owen Stan Paulsen

GE 45-ton weights:

One truck, complete- 16,000 lbs. (8 tons)
Cab and platform/frame, with engines in place- 58,000 lbs. (29 tons)
Engine/generator set with base- 4,350 lbs. (4 1/4 tons)

To lift the frame, use a 20,000 lb (10-ton minimum capacity) jack at each of the four corner jacking points.

Minimum lift to clear trucks for removal- 16 inches.

Does this help?

Howard P.

Yes

Stan