Need Air Reservoir

jonarch · **Joined:** Tue May 22, 2012 1:40 pm **Posts:** 1

I am looking for a 16" x 62-68" main reservoir with center drain cock and air fitting at one end. Does anyone have a source for this?

Lincoln Penn · **Joined:** Wed Feb 02, 2011 9:40 pm **Posts:** 841

If you have a drawing or can make a drawing and specify the maximum working pressure, any ASME code shop can make you one.

David Johnston · **Posted:** Wed May 23, 2012 12:57 am

Several organizations have found Stoystown Tank and Steel to be an economical place to have custom tanks made. http://www.stoystowntank.com You will need to be able to descirbe what you need including the maximum operating pressure. ASME usually require two 2" openings for inspection of the interior. These are usually placed in the center of the heads. You can bush these openings down to the pipe size you need.

If this is for use on railway equipment, you may want to read the FRA requirements for resevoirs before you contact Stoystown at 49 CFR 229.31 and 49.