The Fig. 1-8 lifting cylinder
The is the way to lift in vertical by inclined plane that tilt it 45 deg. I need distant from head to 3/4" in middle an distant to chain.
I need the eye bolt from top of head the middle eye an size that it require.
------------------------------------------------------------------------------------
The is water jacket an liner separation device that I need (4) 5/8-11 long all thread an center to center which should be the as <www.railswap.org> item Lifting Plate B-1 a should also use Lifting Plate B-1 for tool.
------------------------------------------------------------------------------------
The is <www.railswap.org>
All dimension on the drawing I do not have.
Some are there but the one's I don't have is the problem.
-----------------------------------------------------------------------------------
If you can find a drawings, or the measured items at email to me, take the drawings a sent the back to email address.
Thank
Stan Paulsen
[color=#000000][/color]
| Attachments: |
File comment: The Fig. 1-8 Lifting cylinder head
FIG 1-8 Lift head.doc [47.5 KiB]
Downloaded 301 times |
|
File comment: The is water jacket an cylinder to remove rs3-f8-8c.JPG [ 58.72 KiB | Viewed 2212 times ] |
|
File comment: The is <www.railswap.org> Need the bolt an length of parts ALCO 244a1lifter.JPG [ 100.11 KiB | Viewed 2212 times ] |