Railway Preservation News
https://www.rypn.org/forums/

WANTED: Boxcar, Gondola End Sheets
https://www.rypn.org/forums/viewtopic.php?f=2&t=28827		 Page 1 of 1
Author:  Scott Kwiatkowski [ Sun Jan 31, 2010 8:51 am ]
Post subject:  WANTED: Boxcar, Gondola End Sheets
I am looking for end sheets from a boxcar or gondola to finish a gondola restoration project.

See the photos below, it appears that very similar or if not the same stampings was used on both car.
Image

Image

One boxcar end sheet would make two gondola ends.

Thanks,

Scott Kwiatkowski
Pennsy Railcar Restoration LLC
info@prrllc.com
Author:  Scott Kwiatkowski [ Wed Jun 23, 2010 9:18 pm ]
Post subject:  Re: WANTED: Boxcar, Gondola End Sheets
Folks,

I am still looking for end sheets from a gon or boxcar for a restoration project.

Please let me know if there are any cars are being scrapped out. I can come and do the cutting and hauling.

Thanks,

Scott Kwiatkowski
Pennsy Railcar Restorations LLC
info@prrllc.com
Author:  Jason Midyette [ Tue Jul 06, 2010 2:55 pm ]
Post subject:  Re: WANTED: Boxcar, Gondola End Sheets
Perhaps a longshot, but will end sheets from a Union Pacific B-50-2 boxcar work? Car is located in Colorado.

Jason Midyette
Page 1 of 1 All times are UTC - 5 hours [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/