| Railway Preservation News https://www.rypn.org/forums/ |
|
| Adlake Diaphragms https://www.rypn.org/forums/viewtopic.php?f=2&t=32105 |
Page 1 of 1 |
| Author: | Mike At Adlake [ Thu Sep 22, 2011 2:14 pm ] |
| Post subject: | Adlake Diaphragms |
Adams and Westlake will be pulling together a special sale on Single-fold and Two-fold Diaphragms in October. If we combine our orders we can leverage our purchasing power to bring down the price. Let me know if you are interested. You can also visit www.adlake.com or email adlake@adlake.com for more information. Mike Rzeszutko Adams & Westlake 574-264-1141 |
|
| Author: | Hayneshopcat [ Fri Sep 23, 2011 10:50 am ] |
| Post subject: | Re: Adlake Diaphragms |
Can you elaborate on what the price is that we are trying to achieve? |
|
| Author: | Mike At Adlake [ Mon Sep 26, 2011 9:07 am ] |
| Post subject: | Re: Adlake Diaphragms |
It is hard to say what price we are trying to reach. It all depends on what amount of material I need to buy. For now, we just need a "reservation" or estimate on how many people would need. Then we'll see how good we can do, and hopefully save everyone money. For example, if I only make two the price is higher than if I combine 10 orders of 2, so I can buy differently and bring down costs/price. I hope that helps. Mike at Adlake |
|
| Author: | Hayneshopcat [ Mon Sep 26, 2011 9:47 am ] |
| Post subject: | Re: Adlake Diaphragms |
It really doesn't help. Are we talking $50 or $5000? What is the maximum price if you have an order for just one? |
|
| Author: | etalcos [ Tue Sep 27, 2011 1:22 pm ] |
| Post subject: | Re: Adlake Diaphragms |
Mike, the other question is peaked top or flat top, and single or double fold? I can think of several cars around here that could benefit, but just like hayneshopcat, we'd need to determine a ballpark cost for 6 to 8 of them? etalcos |
|
| Author: | Mike At Adlake [ Mon Oct 17, 2011 4:37 pm ] |
| Post subject: | Re: Adlake Diaphragms |
Normally the price for single-fold diaphragms is around $800-900. The two-fold can be $1200+. We are hoping to save a few hunderd for each type. As far as the apex or flat top, when you contact us we will send you a diagram to help distinguish what you want. The material and extrusion are the expensive parts, so we are hoping to buy more than we would for just one small order and be able to bring the price down. I hope that helps. Feel free to contact us at 574-264-1141 if you have some specific quesitons. Thanks |
|
| Page 1 of 1 | All times are UTC - 5 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|