We have been talking about making replica number plates for CNR 6167 for quite some time. Recently a rather nice wood pattern just happen to appear out of the aether, now making such an endeavor much easier.
Is anyone on this board interested in purchasing a replica plate? If so PM me.
The ballpark figure from our conversation was in the $200-$300 range (most likely closer to $200)
Cheers,
Joe
| Attachments: |
|
File comment: A 3D model I drew in Autodesk Inventor years ago. numberplate.png [ 84.73 KiB | Viewed 3547 times ] |